TP-Link wireless routers are one of the most advanced sets
of networking devices. TP-link devices are not only very high-end devices
loaded with some extraordinary features but it is also very easy to use and
even configure. The web address www.tplinkwifi.net
has proven to be of great use when it comes to access the Tp-link wireless
router’s setup page for configuration and further modification purposes. The
users are required to perform this basic setup of configuration on their
devices so that it can be used for networking and internet services.
What to do if I forget the router admin login password?
There is absolutely no need of rushing to any unnecessary
action on your Tplink wireless router, what you need to do is just read the
troubleshooting steps listed below in order to get your router password reset.
If you have forgotten your router’s login password, then
you must have to get your Tplink wireless router reset to its original factory
settings.
There are basically two methods of getting your Tplink
wireless router reset to its original state. These are mentioned are below.
- Router reset through the reset button on the router
- Reset through the web interface of the router
Reset through the reset button of the router
The Tplink wireless router can be reset to its original
factory state easily through the reset button given on the outer body. What you
need to do is just follow the steps mentioned below.
1. Switch
on the power supply and keep it awake and stable.’
2. Now
insert a long pinpointed object like a paper clip or a pin and push the reset
button. Push and hold the reset button pushed for at least 5- 10 seconds.
3. Your
router device will take a reboot itself and you can release the reset button
now and wait for it to get stable again.
4. Till
now, all the settings written on your router’s memory will be erased and you
will have to configure it again to get it in a working state.
Important – As
your Tplink wireless router device has been reset, so as all the details on it
also has been erased. The router device will be rebooted to a whole new device.
* Users
can easily set a new password for logging into its setup page.
* Just
use the default login credentials for accessing its setup page. The default
login password is “password” respectively.
* Access
the Wireless security section of the router’s firmware and then provide the old
password once and the new password twice to confirm and set the new password.
